Designed for single sliding or bi-parting metal or wood doors. Intended to take abuse from trucks, tractors and farm machinery when used around factory and farm buildings. Smooth ramp on each side of the guide prevents cutting tractor or truck tires. Mounts on concrete floors with lag screws and shields or on a 6 in x 6 in post. 1/2 in rod or bolt inserted through hole in each side will serve as a center stop for bi-parting doors. Meets ANSI/BHMA, A 156.14. Manufactured from hot-rolled steel. Boxed.
Designed for use on 1-1/2 in thick wood frame sliding doors. When nailed to the bottom of a wood frame door, these guides engage with #6004 guide rail to prevent wind damage to both the door and building. Pre-punched mounting brackets are attached. Pack loose.
Extra-wide guides are designed for corrugated metal-clad doors, can be used as a door stop when mounted sideways. Curved section of guide may be turned sideways allowing straight access when installing screws. Fasteners are not included. Guides have holes for spikes as well as larger holes for 3/8 in lag screw mounting. Guide is adjustable for doors up to 5-1/2 in thick.
N 6539 is a 4 in long bi-fold door snugger that snaps into the center of the bi-fold door track. The guide pin (N 6545) is inserted between the two springs in the nylon snugger housing. As the door is closed, the snugger slides in the track and makes contact with the opposite set of doors. This applies pressure evenly between guide pins. This causes them to remain in the closed position until one of the sets is grabbed by the knob and pulled outward. Used on Acme bi-fold doors.
N 6611 is a spring-loaded 3/4 in Dia nylon roller guide in a steel nail down base. The base is 3/8 in with 2 nail down tabs on either side. It mounts on the top edge of a bi-fold door that is 1 in to 1-3/8 in thick and up to 30 lb.
N 6614 is a spring-loaded 7/8 in Dia nylon roller guide in a steel nail down base. The base is 3/8 in with 2 nail down tabs on either side. It mounts on the top edge of a bi-fold door that is 1 to 1-3/8 in thick and up to 30 lb.
N 6701 is a Top mount bi-fold door pivot and guide. Used by Johnson Hardware and other door manufacturers, the spring loaded pivot pin inserts into the pivot bracket above creating a top pivot point for the bi-fold door or it serves as a guide for the end door as it slides back and forth in the track. See N 6844 for the Pivot Bracket.
N 6703 is a spring loaded, 7/8 in Dia nylon roller guide in a 3/8 in plastic base. It mounts on the top edge of a bi-fold door that is 1 to 1-3/8 in thick. Commonly used by Kenna Frame as well as countless other bi-fold door manufacturers.
N 6705 is a spring loaded, 3/4 in square glide or guide in a 3/8 in plastic base. It mounts on the top edge of a bi-fold door that is 1 to 1-3/8 in thick. Used by Alliance Doors and many bi-fold door manufacturers.
N 6729 is a guide rod used in Benchmark bi-fold door systems. The 5/16 in Dia, 5-1/4 in long steel rod and is threaded on the bottom half with a hex nut and washer. There is a 3/8 in nylon cap on the end.
N 6761 is a 3-Piece adjustable floor guide. Made of white nylon, the 1-1/4 in tall guides at each end can be adjusted inward to accommodate doors 3/4 to 1-3/8 in thick. Used by many closet door manufacturers.